IZOMAX® C 40
IZOMAX® C40 is a two-component, elastic, cement and polymer emulsion based waterproofing material.
Complies with class CMO1P according to EN 14891.
CM: Cementitious waterproofing material applied in liquid form
O1: Crack-bridging ability (-5°C)
P: Bond strength in chlorinated water
Application Areas
• Indoor and outdoor areas, on vertical and horizontal surfaces
• Waterproofing applications beneath ceramic tiling
• Retaining walls, foundations, and basement walls
• Medium-sized pools and water tanks
• Wet areas such as bathrooms, kitchens, terraces, and balconies
• Walls and floors of cold storage facilities
• Foundations and retaining walls
Advantages
• Easy to prepare and apply
• Elastic structure offers a continuous, wide application range
• Can be applied with a brush, trowel, or sprayer
• Water-repellent yet vapour-permeable
• Does not shrink or crack
• Provides very high bond strength
• Resistant to freeze-thaw cycles
• Waterproof, with a water penetration resistance of 4 bar
|
General Information |
|
|
Material composition |
Special cement, mineral fillers, liquid polymer emulsion, and special chemicals |
|
Elasticity class |
CM01 elastic |
|
Appearance |
Grey |
|
Density (mixed) |
~1.90 kg/L |
|
Performance Data |
|
|
Initial bond strength (EN 14891) |
≥ 0.50 N/mm² |
|
Bond strength after water contact (EN 14891) |
≥ 0.50 N/mm² |
|
Bond strength after heat ageing (EN 14891) |
≥ 0.50 N/mm² |
|
Bond strength after freeze-thaw cycles (EN 14891) |
≥ 0.50 N/mm² |
|
Bond strength after contact with chlorinated water (EN 14891) |
≥ 0.50 N/mm² |
|
Crack bridging +20°C (EN 14891) |
≥ 0.75 mm |
|
Crack bridging −5°C (EN 14891) |
≥ 0.75 mm |
|
Capillary water absorption (EN 1062-3) |
≤ 0.10 kg/m²·h⁰·⁵ |
|
Watertightness (EN 14891) |
Watertight (150 kPa / 7 days) |
|
Water penetration resistance |
≥ 4 bar (positive) |
|
Application Data |
|
|
Application temperature |
+5°C / +35°C |
|
Service temperature |
−5°C / +60°C |
|
Mixing ratio (powder / liquid) |
25 kg powder component / 10 kg liquid component |
|
Pot life |
~2 hours |
|
Waiting time between coats |
Min. 5 hours |
|
Waiting time before tiling |
Min. 1 day |
|
Time to become watertight |
7 days |
|
Full cure time |
Min. 48 hours |
|
Time before exposure to use |
1 week |
|
Number of coats |
2–3 coats |
|
Consumption |
1.20–1.40 kg/m² (per coat) |
|
Safety Data |
|
|
Hazardous substances |
Refer to SDS |
The figures stated above are valid at an ambient temperature of +23°C and 50% relative humidity. Higher temperatures shorten the time, while lower temperatures extend it.